Decoding models.lst
Alles über iStripper
28. September 2016, 40 antworten
Clips in Small mode are positioned over a Hot Spot. This spot is remembered, and it becomes the starting Spot for the Next Small clip in that position.
The Hot Spot Could Be Linked to the Top of an Open Window, it it will move around with that window.
When you Quit iStripper, and then Re-start it, These Saved Hot Spots are Reloaded, and re-used.
They are Generated using a formula that Calculates the Available Width, and places it in the Middle of the Width.
This then Divides the Space in half, and the Next Spot is calculated based on the Now Half Width..
Until there isn't enough Space for a new clip.
If you Want to Have New Spots, then Delete the file called entrances.dat in the Data folder.
If a remembered hot spot was attached to a window that no Longer is open, it is forgotten and a new one takes it's place.
itNN clips
it01 - Hang around Hot Spot ( or Center of Screen if clip is starter at center screen )
Might Walk around, but returns to Hot Spot.
it04 - Fall to a Standing position
it05 - the Hanging clip - as when you ***** an interactive clip
it06 - Exit to the Right side
it07 - Exit to the left side
it10 - Stand to Sit transition
it11 - Part of Magic
it12 - Sit to Stand Transition
it13 - Fall to Sitting position
The Magic Spin is to Get Dressed or to get naked.
Except for it11
there are .demo ( clothed ) and .vghd naked versions of each itNN type.
Sometimes there are more than One of the it01, it06 and it07 types.
these would be other variations. One Might just stand around, one might Tap her wrist like she's waiting...
the attached picture shows a sample of 6 active hot spots on my screen.