In tutorial, it shows that one can have a model sit on a partially open screen window. Is it doable/possible? I tried but with no success. It is tempting to see the full model to include the full length of the legs below the task bar on the screen.
Appreciate any tips.

Yeh, ***** the girl to just above the bar and drop her.

Guess the new wanna-be moderator hasn't seen this one.

Make the girls very small size in settings eg 15%

Left click on the cirl and drage her to the top of the screen above the window you want o us. Relaease her and she will drop onto the window.. You can then resize back up to 60%

TBH it is a bit fionicky but it does work as per the attached screenshot.

If you have a search around the forums @Wyldanimal did a simple programme that simulates an open window that allows tou to puy moderls ate various positons an hid the windows.

IT WORKED!

Guess the new wanna-be moderator hasn't seen this one.

No intentions of beiing a moderator @Chicsans...
Already given in the past.
😖

Was just trying to not get the same subject alive in three spot of the forum.
Next time I will pass by...
😒

Glad it worked @baslal.
👍

Hi @baslal

Be sure that you ***** the girl just between the top of your windows screen and the top of the new dcreen and than drop her, Her hands ,and feet may not touching both top sides because that causes modt of the time that thr girl will drop on tha taskbar. The girl must have a little space to jump on the top the new dcreem.

Join your iStrpper sunday

The walking transition clips are the only downfall to this. It's hard to keep the girls walking off when they play. This is one of the times a ''disable transitions option'' would be very usefull. I love @Wydanimals stage app. but don't use it much unless it's a specific cliptype playlist that avoids transitions the most. Usually it's pole clips only when I do this. Even table clip lists sometimes include the ''get up from floor'' clip that ruins it.

I love @Wydanimals stage app.

Since the stages can be Made Invisible ( hidden )
You can Make the Stage Stretch across the Whole screen Width to avoid walkers falling off

https://www.istripper.com/forum/thread/39487/1?post=581116

您不允许看到该主题或访问与该主题相关的数据

In case you want to give it a try...
Here is an Updated version of my 10 Stage control

You can Save the Current Stage Settings, and Load them again later.
( currently only One Saved Setup is supported. Maybe I will write a routine to allow Naming of the saves )

This is very Different from the Single Stage App.
The Control has Stage Selection Dots.
Each Dot provides control for One of the Stages.
Select the Dots, then Control all of the Selected Stages.

• One Control Box, is used to Control All of the Stages.
• To Position a Stage, use the mouse to Click and ***** the Stage.
( making the Stage thicker helps to make room for the Mouse )
(then make the stage thin after you position it )

• Right click a Stage to Hide it.
• Double Click a Stage to Make it Full Width, and set the Left to the Left side of the Screen.

http://www.virtuastripper.net/files/iStages.zip

Demo Video

http://www.virtuastripper.net/video/iStages-001.mp4